View full version: General Discussion
  1. Interior Upholstery Color
  2. Floor Mats
  3. Heater Levers
  4. Grommets for positive battery cable
  5. Can I fit 6J x 14" alloys on a 230SL 5.5J x 14"
  6. Sun visor struggle ?
  7. Body plate
  8. Oil cooler hose
  9. refurbishing VIN plate
  10. 1970 speed relay and 2 way valve
  11. Reverse gear in automatic
  12. Cold Start Valve Relay Fix 1970 280SL
  13. RPM drop when using electricity
  14. Rear Axle Compensating Spring
  15. Hood secure strap:
  16. Water Pump & Fan Cluch Replacement
  17. anyone know the part # for the aluminium
  18. Correct paint pattern
  19. Low Vacuum Reading
  20. Correct Nardi Hub
  21. Stuck Soft Top
  22. Motor run one second only
  23. injection pump and speedometer cable
  24. Need expert Car Polishing Dallas Texas
  25. rust prevention ...
  26. Speyer 113 gathering of 360+ pagodes
  27. Cold Start Valve
  28. Adhesive for rubber seals
  29. 0231 185 010 distributor timing?
  30. Heater valve/slide connection?
  31. Nomenclature for lights
  32. clutch is making noise when engaged
  33. To repeat or not to repeat...
  34. Fuel Tank
  35. Converting '71 280 SL to Electronic Ignition
  36. Stuck Softtop
  37. Tech session at Van Dijk in Holland
  38. ballast resistors
  39. Model Wire Pagoda
  40. Window Adjustment
  41. Convertible Top Cover trim
  42. distributor/timing question
  43. Shift Gate Light?
  44. Eliminating rattles
  45. Changing Differential Gears For Better Mileage
  46. Top end clatter ?? Chain tensioner ?
  47. Hood torsion bar
  48. Is my 230Sl commuter friendly?
  49. Replacing trim
  50. Archive closing--got your datenblatt???