View full version: Drive train, fuel, suspension, steering & brakes
  1. Want to up-grade A/C to new 134 and rotary compressor
  2. Refurbishment of Hand Brake Cables?
  3. Cylinder Head Markings
  4. Fouling plugs
  5. yellow wire through fire wall
  6. 280sl Cylinder head.
  7. Exhaust system hanger question...
  8. 230sl engine block replacement
  9. 6 speed manual gearbox for 113
  10. Valve Cover Bolts
  11. ZDDP engine oil additive for older engines
  12. Threaded holes in back of block
  13. difficulty shifting after driving for a while
  14. Engine block drain plug and washer
  15. King Pin Replacement - I've hit a snag
  16. Various engine noises and missing on part throttle
  17. Should my Automatic start in 1st or 2nd?
  18. Cross over linkage
  19. Rear axle to prop shaft seal replacement
  20. transmission: (Please disregard this thread)
  21. Brake and fuel lines and hoses on a 1964 230sl
  22. Jack stand support points when removing rear end?
  23. What is this noise? Suspension, or perhaps engine or steering mounts?
  24. To Shock or not to Shock
  25. Points - Parts Geeks Only
  26. shock cover
  27. Oddball setup
  28. 280Sl 4 speed manual clutch biting point very low
  29. Brake Booster help
  30. crankshaft seal & spacer/racer removal and new installation
  31. Leaking fuel pump
  32. Fan belt issues
  33. drive shaft length
  34. Expensive Shifter
  35. Suspicious Bolt (Now Solved) . Thanks
  36. transmission problem
  37. What's Your Intake Manifold Vacuum at Idle Speed?
  38. Heater Hose / Engine part number?
  39. Picture of Heat Shield between intake and exhaust manifold with 2 clamps needed
  40. Fan clutch not desengaging early enough?
  41. Factory tire size - what profile?
  42. "Waterless" water in the cooling system.
  43. Repair kit fuel pump
  44. tire size options
  45. Picture of Transmission Switch Needed
  46. 250 SL AT Shifts Problems
  47. Picture of Mounting Bracket for 2 screw terminal block near oil pan needed
  48. Picture of Mounting Rings for Battery Cable needed
  49. Water pump gasket removal
  50. Picture of 3 rubber bushings for air filter housing needed