3d Part modification

[yves]

I am repairing "again"  the cylinder of the light for the heating levers and have used the 3D file on the tech manual and saw a modification to do because it's difficult to fit the electric pin exactly in the correct location .  i have to grind a very thin groove in the plastic part cover to match with the "tab" at the bottom of the pin. The stop on the 3D part is located too far in a rear position.
I hope you understand my basic english.... may be it's more easy with the photos below ...!

[yves]

The 3D part fitted . I'll have to test the light through the "white cylinder" even with a LED  it may be darker than with the clear original one !

[Sead]

You wont get much light through these white cylinders...
you can buy clear one plexyglas cylinder... I made myself both new...

[Pinder]

Excellent work!

[dirkbalter]

I am repairing "again"  the cylinder of the light for the heating levers and have used the 3D file on the tech manual and saw a modification to do because it's difficult to fit the electric pin exactly in the correct location .  i have to grind a very thin groove in the plastic part cover to match with the "tab" at the bottom of the pin. The stop on the 3D part is located too far in a rear position.
I hope you understand my basic english.... may be it's more easy with the photos below ...!

I believe I created the model a while back. I couldn’t find the parts then. It worked for me but I am happy to modify it if you can supply dimension and or sketch.