Rear licence plate bracket?

[Shvegel]

Is there a bracket for the rear license plate or is it simply bolted to the rear panel?

[Peter]

I have a chromium bracket (Europe format) which them is bolted to the rear panel, see picture inside.

[MikeSimon]

The chrome moulding sits under the rear license plate. P/N 113 698 0081. Other than that, the plate mounts plain to the rear panel.

[GM]

I made a bracket to adapt the existing holes to fit my license. Used small rubber standoffs between it and the paint to prevent chafing

[neelyrc]

See the information in the following link:

https://www.sl113.org/forums/index.php?topic=15847.msg183273#msg183273

[balimatharu]

My 250sl has gone through extensive restoration. Rear panel and both quarter panels were renewed.
There are no holes for the moulding or the number plate. I am thinking of sticking both with 3M double sided tape.
Is that ok. Please comment.
Thank you
Bali

[neelyrc]

Why not just drill the holes?

[Pawel66]

My 250sl has gone through extensive restoration. Rear panel and both quarter panels were renewed.
There are no holes for the moulding or the number plate. I am thinking of sticking both with 3M double sided tape.
Is that ok. Please comment.
Thank you
Bali

I did that 6 years ago and it is holding. I used no frame. I used the double sided adhesive tape for the chrome trim under the license plate as well. There are special tapes for gluing in the emblems, but I guess a good 3M will do.

[balimatharu]

Thanks all for the comments.
Bali.