W113 Pagoda SL Group > Body, interior, paint, chrome, and cosmetic items
Seat cross members
(1/1)
swood1:
Hi all,
Just welding in a new seat cross member (the large panel in the middle that the seat bolts too), am I correct in assuming this should be perfectly horizontal to the body otherwise the seats will be wonky? The new panel I have looks to be too high on the outer edge (closest to the sill), I reckon it's about 10mm too high as supplied (compared to the original), but shall check again this evening.
Regards
Steven
hauser:
Someone in Europe is adding coil springs to the bottom frame of the seat.
swood1:
I'm not sure that would help with much unless you found the seat too hard... The better option maybe to add something that would allow for height adjustment surely.
I am going to modify my panels to make them horizontal as cannot see why they would ever need to be sloping.
Steve
Navigation
[0] Message Index
Go to full version