Pagoda SL Group
W113 Pagoda SL Group => Research & Development => Topic started by: dirkbalter on October 28, 2021, 17:13:33
-
I just uploaded some 3-d models for the heater assembly if someone needs and wants to print theses. The caps tend to crack and break easy. I didn’t need the tube and I am not sure if clear plastics can be printed.
-
Nice. Add the files to the 3D printer section in the tech manual 👍
-
I did. Pls check for me.
-
Where did you put them? I created a 3D print section here.
https://www.sl113.org/wiki/Restricted/3D-Printed-Parts
-
I thought I did it correct but don’t see them.
-
I checked the TM 3D page editing history. There were not any edits by you. Maybe you put them somewhere else or didn't save???
Anyway, I added them to the page. Soon we should be able to print a 3D pagoda :o :o :o ;)
-
I checked the TM 3D page editing history. There were not any edits by you. Maybe you put them somewhere else or didn't save???
Anyway, I added them to the page. Soon we should be able to print a 3D pagoda :o :o :o ;)
Appreciated.