Pagoda SL Group
W113 Pagoda SL Group => Body, interior, paint, chrome, and cosmetic items => Topic started by: Green68MB on October 08, 2020, 17:23:58
-
Is the accelerator pedal mount welded to the floor panel or is it just attached to the rubber pedal? When I pulled up my carpeting , I found rust at the exact area and wondered if it broke loose or was never attached. Any info is appreciated. Thanks
-
Its welded to the floor.
-
Thanks, After I pulled the carpet up the mount was loose and still attached to the rubber pedal.
-
If your floor panels are still strong enough, you can weld it back in. I took some dimensions before I removed my bracket and can post them if needed.
(Not sure if I would go that route but if welding is not an option, you could probably drill holes and screw the bracket to the floor.)
-
Thanks, the screw solution seems most probable
-
Hi Dirk,
Would you mind posting your dimensions please? I am just going through process of replacing my floor panels. The original bracket was missing.
Regards
Steven
-
Steven,
The dimensions I wrote down before I cut the floors out:
3 3/4" (85.7mm) from the tunnel wall to the outer edge. See pic
2 1/4" (57.1mm) from the transition of the floor panels to the front edge of the bracket. See pic
Hope that helps
-
Hi Dirk,
Thanks very much for this information.
Kind Regards
Steven