Pagoda SL Group
W113 Pagoda SL Group => Drive train, fuel, suspension, steering & brakes => Topic started by: CJHenderson on April 08, 2019, 21:12:33
-
Getting ready to finish the rear axel and do I need a gasket or gasket maker for the bracket for the drive shaft receiver?
-
I use a sealer like Permatex gray on that area. I noticed that your axle boot isn't installed correctly. The split should be parallel with the floor so that it's not under any tension when the axle tubes are fully extended.
-
Thanks for catching the error, much appreciated.