Pagoda SL Group
W113 Pagoda SL Group => Drive train, fuel, suspension, steering & brakes => Topic started by: Pawel66 on February 18, 2018, 00:07:43
-
In the Automatic Transmission parts drawing we can find these grommets.
Do you know where they go exactly? 2 pieces each are needed for a car.
I can figure out the bigger one goes between the line and a clamp in 2 places, but I am having problems figuring out where the smaller goes and how to install it. The bigge one is cut. The smaller one is not - it is a small pipe. I would have no idea how to slide it on any of the thin lines (it has a dimeter like a fuel injection line or the vacuum transmission line) as they have banjo connectors at the ends. The smaller ones also should go between a line and a clamp (intuitively), but I would not know how to place them without cutting.
Do you just cut it along?
-
The smaller one should go on the vacuum line from the intake manifold, there is a bracket holding it down 10-15 cm from the manifold.
Radu
-
Radu, thank you! So you need to cut it as it will not go through the banjo connector on the vacuum line...
-
Probably, maybe when they made these pipes the first time they mounted the grommet before they crimped the connectors.
-
Ok, thank you.