Pagoda SL Group

W113 Pagoda SL Group => General Discussion => Topic started by: Yi Li on March 12, 2023, 16:21:22

Title: Removal of Engine Oil Dipstick Tube
Post by: Yi Li on March 12, 2023, 16:21:22

Hello, I have a 1968 280SL.  It runs well.  But I recently found I have to pull very hard to remove the engine oil dipstick and the upper portion of the dipstick is rusty.  I can feel middle section of the tube is very tight. is this due to rust or collection of oil sludge?  Is there a way to remove the tube and clean it?    I did not see a bracket on the tube to fix it to engine body. Should I just pull tube upper or turn it to remove?  Thanks in advance!

Title: Re: Removal of Engine Oil Dipstick Tube
Post by: WRe on March 12, 2023, 16:38:35

Hi,
see here: https://www.sl113.org/forums/index.php?topic=34491.msg252320#msg252320.
...WRe

Title: Re: Removal of Engine Oil Dipstick Tube
Post by: Yi Li on March 12, 2023, 21:54:57

Thanks for the quick response.  Can I clean the tube without remove it?  I may use a stick wire brush to get rust or sludge off, but debris will fall into the oil tank.  I can change oil immediately, will this hurt engine?  Are there any other advices on how to clean the tube?
Thanks again!