Pagoda SL Group

W113 Pagoda SL Group => Drive train, fuel, suspension, steering & brakes => Topic started by: PeterPortugal on December 23, 2019, 13:37:11

Title: Engine Mount Limit Stops
Post by: PeterPortugal on December 23, 2019, 13:37:11

Hi All,

As per some other posts all my "limit stop" hardware was missing from the engine mounts which I removed from my car.

The problem I have is that my usual resources for new parts seem to be limited to the later style version with a hex head bolt fitted to secure the limit stop (127-220-00-71).

My 1963 220SE/C should have an M12 x 50mm threaded stud with two nuts, one to get the correct compression on the rubber washer plus a locknut.

Can I use the later style hex head bolt as used on W113?

Regards

Peter

Title: Re: Engine Mount Limit Stops
Post by: PeterPortugal on December 31, 2019, 11:28:15

Hi all,

Thought I would give this one a push.

As per the image below my car should have the hardware on the left (same as early 230SL) but it is all missing.

Can I fit the later version hardware shown on the right which is readily available?

Regards

Peter

Title: Re: Engine Mount Limit Stops
Post by: ja17 on December 31, 2019, 14:52:33

Yes, changes over with no problems.

Title: Re: Engine Mount Limit Stops
Post by: PeterPortugal on December 31, 2019, 16:23:08

Hi Joe,

Thanks for replying and may I take this opportunity to wish all forum members a very happy New Year !

Regards

Peter

Title: Re: Engine Mount Limit Stops
Post by: cfm65@me.com on December 31, 2019, 21:37:26

Thanks Peter,
Happy, happy to you and your loved ones as well.
Regards
Chris
Cape Town