Pagoda SL Group

W113 Pagoda SL Group => General Discussion => Topic started by: bpossel on February 14, 2005, 07:26:19

Title: Hans Utke - What do you think?
Post by: bpossel on February 14, 2005, 07:26:19

Hi Hans,

What do you think?  Looks like oil?

Thanks!
Bob

Download Attachment: (http://images/icon_paperclip.gif) ip.jpg (http://www.sl113.org/forums/uploaded/bpossel/200521482547_ip.jpg)
55.69 KB

bpossel
Memphis, TN.
1971 280SL
1997 E320

Title: Re: Hans Utke - What do you think?
Post by: Cees Klumper on February 14, 2005, 16:45:43

I have that very same dribble [:(!]. Can someone tell us what causes it please?

Cees Klumper in Amsterdam
'69 white 280 SL automatic

Title: Re: Hans Utke - What do you think?
Post by: ja17 on February 14, 2005, 18:23:56

Hello,
Yes looks like oil leaking between the warm up device and the pump body. The centrifical governor in the injection pump is probably throwing  some oil upward. Try coating the two parting surfaces and the shim with some very thin sealer. Maybe just a thin coat of silicone sealant. Tighten everything down while the sealer is good and soft. Be careful not to allow any build up since the slightest change will change the injection mixture!

Joe Alexander
Blacklick, Ohio

Title: Re: Hans Utke - What do you think?
Post by: bpossel on February 15, 2005, 06:31:45

Hi Joe, thanks for the advice!

I spoke to Hans yesterday.  He said the same thing...  Remove the 2 screws, leaving all else connected.  Apply a thin coat of permatex between the housing and the shims.  This should cure the small leak.

Regards from Memphis!
Bob

bpossel
Memphis, TN.
1971 280SL
1997 E320

Title: Re: Hans Utke - What do you think?
Post by: J. Huber on February 15, 2005, 09:43:36

While on the subject, is it possible that this leak can splat or spray oil as well? Every once in a while I get a very light splatter on the underside of the hood. Just wondering where it originates...

James
63 230SL

Title: Re: Hans Utke - What do you think?
Post by: n/a on February 21, 2005, 17:32:32

Warning! Let out some of the cooling water before you remowe the 2 screws. The thermostat inside the house will proberly fall out and water will come out!