Pagoda SL Group

W113 Pagoda SL Group => General Discussion => Topic started by: chrislohrcdm on January 23, 2018, 02:20:04

Title: Still Need Help Identifying Where Pieces Go
Post by: chrislohrcdm on January 23, 2018, 02:20:04

Hi all,

With your help I have put the brackets on that you sent me pictures of.  There are these two things left and then I am done.  Can anyone help?

Thank you!

1969 280 sl automatic

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: Pawel66 on January 23, 2018, 07:50:38

The wire - is it not the three-way solenoid wire for the automatic transmission?

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: Naj ✝︎ on January 26, 2018, 11:56:21

#1 looks like the brkt that holds the air pipe to the inlet manifold with a 'P' clip.
The pipe runs from under the manifold round the back of the engine to the little air filter on the inj. pump.

naj

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: mrfatboy on January 26, 2018, 13:12:32

I can't be sure but the top picture looks like part of the bracket that holds the upper steel oil line coming from the oil filter that attaches to the block around tach connection area.

The picture would be missing the clip that wraps around the pipe and bolts on to the bracket.

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: 450sl on January 26, 2018, 13:12:42

wire  startermotor or alternator  to connectionstrip under rightfront engine?

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: mrfatboy on January 26, 2018, 13:40:08

I just happen to have the part that Naj is talking about on my dining room table along with half my engine.  The wife has not yelled at me yet😆😆😆

It does look closer to your pic because of the off angle bend.

The oil line bracket that I was taking about (also off my car) is a normal right angle bracket.

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: cfm65@me.com on January 26, 2018, 18:52:06

Chris,
The wiring in the middle photo has three different size ‘connecter’ rings. Those rings go to the electrical connecter under the LH side of the auto box. The other side of that little loom goes to the constant speed solinoid, kick dn switch, etc.
Look at the three different size wire connectors in the photo attached.
Regards,
Chris
Cape Town

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: chrislohrcdm on February 04, 2018, 19:22:38

Thank you so much!

Quick question.  What is the auto box? 

Thank you!!!

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: Pawel66 on February 04, 2018, 20:03:51

We talk about the three-way solenoid on the automatic transmission. Auto box = automatic gear box.

Title: Re: Still Need Help Identifying Where Pieces Go
Post by: chrislohrcdm on February 04, 2018, 20:53:41

Great!  Thank you!