Pagoda SL Group

W113 Pagoda SL Group => General Discussion => Topic started by: batman on August 14, 2015, 10:34:33

Title: Heater lever control system
Post by: batman on August 14, 2015, 10:34:33
This afternoon cleaned the heater/air control system, cleaned out the clear light cylinders & the black plastic tops, checked wires to globes for any rust, installed new levers and re-assembled.

To anyone doing this: I cannot stress enough to be very very careful when putting back together the plastic cylinders with the 2 top screws and 1 bottom screw. I slightly overtightened and broke a small piece of the plastic and had to superglue back. Even though in good condition the plastics are almost 50 years old and has some brittleness.

Will install tomorrow
Title: a
Post by: mbzse on August 14, 2015, 13:42:55
a