Pagoda SL Group

W113 Pagoda SL Group => General Discussion => Topic started by: batman on March 01, 2015, 08:35:24

Title: Trunk Liner Panel
Post by: batman on March 01, 2015, 08:35:24

Hi all,

The left hand side trunk (boot) liner panel is missing on my 280.

I have found new one for sale for (genuine Mercedes) for $180 plus shipping (probably another $70).

Has anyone made their own and if so is it very difficult to do and what are the materials (I assume I could borrow someone's and use as a template) or should I just bite the bullet and spend US$250?

Thoughts of anyone

regards
mark

Title: Re: Trunk Liner Panel
Post by: Paul & Dolly on March 01, 2015, 09:32:09

Hi mark

I had some dark gray non-flammable thermal insulation foam sheet 1/2", in the garage,

so I made my own , it also then protects the panel from internal damage.

I made a template from newspaper, as there are a few cabled to be accomadated,
I stuck the foam on with double sided carpet tape.

Minimal cost.

Good luck

paul

Title: Re: Trunk Liner Panel
Post by: kampala on March 02, 2015, 01:46:34

I was searching for seat pads and ran across this item --- not 100% sure if this is the trunk panel you are looking for -- but it's described as a left side trunk panel for w113 --- 24 euros -- again, not sure if this is the same.

http://www.cabrio.de/khm/en/padding-panels-backseat/panels-and-seat-paddings/mercedes/113sl/Trunk-side-panel-113-left-structured-board-detail

Title: Re: Trunk Liner Panel
Post by: batman on March 02, 2015, 10:17:19

Many thanks - looks like it and for the cost will try it!

Title: Re: Trunk Liner Panel
Post by: tel76 on March 02, 2015, 20:29:10

SLS has them in stock

Title: Re: Trunk Liner Panel
Post by: batman on March 03, 2015, 02:12:43

Hi Eric,

I searched their site and could not locate them.

What sub-grouping are they located under?

cheers

Title: Re: Trunk Liner Panel
Post by: tel76 on March 03, 2015, 08:39:37

Hello Mark,
Have a look at 68b item 75, they are in stock a little pricey, if I were you I would get some hard board and make them myself.

Title: Re: Trunk Liner Panel
Post by: Dave H on March 03, 2015, 10:02:27

I have 2 new ones in the Garage at home still in the package.
When i return from work this evening i shall take many photographs and do 2 templates on A3 paper.
If i include all dimensional measurements , openings and cut outs im thinking they can be printed A3 and you can make a set.
Give me a few hours.

Title: Re: Trunk Liner Panel
Post by: Dave H on March 03, 2015, 19:39:59

Hi Mark

Should be easy from these templates.
Get 4 sheets of A3 and mark out the cardinal points as per ...
Leather effect card is the same as on many ring type files.
Fully covered in foam on the reverse.
Best of look.

Right side

Title: Re: Trunk Liner Panel
Post by: Dave H on March 03, 2015, 19:42:29

Left side

Title: Re: Trunk Liner Panel
Post by: Dave H on March 03, 2015, 19:43:37

Close up

Title: Re: Trunk Liner Panel
Post by: batman on March 03, 2015, 20:49:34

Many thanks Dave - I'ii give it a try this weekend