Pagoda SL Group

W113 Pagoda SL Group => Drive train, fuel, suspension, steering & brakes => Topic started by: rutger kohler on April 08, 2014, 07:54:36

Title: Table for aluminium sealing washers.
Post by: rutger kohler on April 08, 2014, 07:54:36

I have just had my oil filter and block, petrol pressure regulator, and petrol filter bodies bead blasted etc.  I have also had the hoses and pipes around these gold passivated (coated).  In doing so I have had to replace all the aluminium sealing washers.  It has been a bit of a job measuring these and replacing them so I have made up a Table in Word (attached) which may save others some time. If it is deemed worthwhile perhaps someone might put the Table in the manual?

Title: Re: Table for aluminium sealing washers.
Post by: 230slhouston on April 09, 2014, 00:56:07

Thanks for the info.
Do you have pics to share....before and after? I spoke to someone today about the same.
Thanks
MBP

Title: Re: Table for aluminium sealing washers.
Post by: rutger kohler on April 10, 2014, 05:57:04

Hi MBP I am holidaying in Sydney Australia for a month but when I get back to NZ I will take some before and after photos  if you like.  Andy Baker lent me a spare set of these so I could re-furbish them and leave mine on until I am ready to swap over.