Pagoda SL Group

W113 Pagoda SL Group => Body, interior, paint, chrome, and cosmetic items => Topic started by: JPMOSE on November 21, 2010, 15:54:13

Title: Wood Speaker Cover - Need Description of Screws
Post by: JPMOSE on November 21, 2010, 15:54:13

I have a small pile of screws and can't figure out which two are for the speaker cover!   Could someone describe approximately what length and finish the subject screws are?   

I'm usually so good about marking and separating items but blew it this time.  Thanks in advance!

Title: Re: Wood Speaker Cover - Need Description of Screws
Post by: stickandrudderman on November 21, 2010, 18:02:42

They're quite unusual screws; around 20mm long self tappers, chrome plated and thin (around 2mm).
If you gt stuck I can provide you with MB part number.

Title: Re: Wood Speaker Cover - Need Description of Screws
Post by: JPMOSE on November 21, 2010, 18:20:46

Thanks....then that means I found one of the two!   I have the part number but it is NLA (at least is was for my 280SE 3.5...I'll check the EPC and see if they're the same part number). 

Title: Re: Wood Speaker Cover - Need Description of Screws
Post by: 66andBlue on November 21, 2010, 18:47:48

Lens head countersunk screw DIN 7983 22x2.9 mm
blunt end, not self-tapping!

Title: Re: Wood Speaker Cover - Need Description of Screws
Post by: JPMOSE on November 21, 2010, 18:54:42

A picture's worth a thousand words!  Thanks to both of you!