Pagoda SL Group

W113 Pagoda SL Group => Body, interior, paint, chrome, and cosmetic items => Topic started by: asjmplisson on March 29, 2010, 01:52:07

Title: Heater Blower harness : question ?
Post by: asjmplisson on March 29, 2010, 01:52:07

Can somebody tell me what is the purpose and where should be connected the third connector of the heater / Blower harness ?

See the picture attached ... I know that :

- The left connector goes to the Blower
- The middle connector goes to the blower command
- I don't know what is for and where the connect the third one on the right . ?

Thanks ???

Title: Re: Heater Blower harness : question ?
Post by: jeffc280sl on March 29, 2010, 01:56:54

How about the clock?

Title: Re: Heater Blower harness : question ?
Post by: asjmplisson on March 29, 2010, 02:32:38

I think you are absolutely right ... Thanks a lot ....

now my big unknown is how do I connect this Harness connector with my clock ... (see picture attached) ... do I need to find a "male" connector to get into the harness connector ? (see picture)

Any idea where I can source both : the clock bracket and the connector.
Does anybody has a picture of the clock bracket ?

Title: Re: Heater Blower harness : question ?
Post by: jeffc280sl on March 29, 2010, 14:00:18

On my car the connector plugs right into the back of the clock.  The clock in your picture does not look right to me.

Title: Re: Heater Blower harness : question ?
Post by: w113dude on March 29, 2010, 22:20:47

The clock in the picture is a w114/w115, If the diameter fits in a Pagoda all you need to get is the positive to the flat connector, the screw mounts are the ground.

Title: Re: Heater Blower harness : question ?
Post by: asjmplisson on March 30, 2010, 00:37:56

Thanks for the answer ! ... And help.

Title: Re: Heater Blower harness : question ?
Post by: graphic66 on March 30, 2010, 01:07:42

You may want to wire the light bulb to the wire that is for the dash lights. Just put your tester on the pins until you find the wire that energizes with the headlight switch[dash lights] and wire that to your bulb in the clock. I strongly advise against cutting or splicing into the existing car wiring. Keep it so you can later wire in a correct clock if ever desired. Try to find a connector from your old clock or something that hooks to the plug in your car without cutting wires.