Pagoda SL Group

W113 Pagoda SL Group => Drive train, fuel, suspension, steering & brakes => Topic started by: markh on May 19, 2009, 12:07:20

Title: csv on 1965 230sl
Post by: markh on May 19, 2009, 12:07:20

checked out csv and found it not spraying fuel removed from car and after examining valve found the black rubber insert all swallen and split i am in england could anyone tell me if there is a repair kit for these or anyone that recon them many thanks   mark

Title: Re: csv on 1965 230sl
Post by: Naj ✝︎ on May 19, 2009, 13:19:47

Hello, Mark,

There is a small 'O' ring between the solenoid and needle valve and a bigger 'O' ring between the valve assembly and inlet manifold. Are you talking about one of these?
They are available separately from MB.

naj

Title: Re: csv on 1965 230sl
Post by: markh on May 19, 2009, 14:24:51

hi no its not the o rings  i have removed the solenoid off the csv and there is a rubber insert about 1 cm long which is pushed in the valve have called mb here and there saying no repair kit so what now   regards mark h

Title: Re: csv on 1965 230sl
Post by: Naj ✝︎ on May 19, 2009, 14:31:38

Hello, Mark,

Besides the 2 O rings, there are no other rubber parts in the csv.

Have a look in the wiki:

http://www.sl113.org/wiki/Engine/ColdStartValve

naj

Title: Re: csv on 1965 230sl
Post by: markh on May 19, 2009, 15:36:26

hi naj just looked at csv tec sheet and it does not show this insert but honest i have taken thie rubber sleeve out it sits where the small o ring should be but fits down the hole where solenoid needle lives confused i am   regards marh

Title: Re: csv on 1965 230sl
Post by: Naj ✝︎ on May 19, 2009, 18:19:28

Maybe the PO did a mod  ???

naj