Pagoda SL Group
W113 Pagoda SL Group => Body, interior, paint, chrome, and cosmetic items => Topic started by: stratmanedh on September 10, 2010, 21:26:47
-
I found a great shop in orlando to handle the retsoration on my pagoda, trunk rebuild, fenders and engine bay. They have quite extensive high end & european experience,,, but not much with pagodas. So, id like to retain a 113 expert..one that knows every inch of the car & how it should be done..correctly. To be available to consul;t via phone and email when they have questions. Any one interesetd for a fair hourly rate??
Not doing a complee dismantle & frame off ..but will have questions
-
Go to the motoring investments homepage
http://www.motoringinvestments.com
Go to Mercedes for sale. Go down to car #46 a blue 113SL it's about 30 cars down. Go to the photo page and click on any photos you want enlarged.
I copied every one of these photos as a benchmark of what the car should look like. It's beautiful.
-
I'd be happy to do it but I'm afraid my travel expenses would be quite high!
-
I recently purchsed a 280SL that was disassembled for bodywork and paint (someday I will post pictures). I then joined this site as a full member since I recognized the value of the site after reading a number of posts. Since joining I have had two great experiences in just the last couple of weeks. In one case I asked aboujt brake calipers that I found a bit unusual and in the second case i discovered a kindred spirit about an hour away from where I live who has offered me help as I figure out the puzzle. In my case, most of the big stuff is pretty obvious (yes, I've already figured out where the engine goes) but for some of the smaller fasterners and SL specifc issues I plan on asking questions here and hopefully my good fortune with replies and help will continue!
Lee
-
So, id like to retain a 113 expert..one that knows every inch of the car & how it should be done..correctly. To be available to consul;t via phone and email when they have questions. Any one interesetd for a fair hourly rate??
Not doing a complee dismantle & frame off ..but will have questions
Ask your questions here on the forum.
You'll have more than one 113 expert responding and it won't cost that much...
naj
-
thanks to all thus far