Pagoda SL Group

W113 Pagoda SL Group => General Discussion => Topic started by: Brennie on June 27, 2021, 09:00:26

Title: Interior rear view mirror
Post by: Brennie on June 27, 2021, 09:00:26

Hi …I’ve just had my SL230(all chrome) mirror rechromed..all good but, the actual mirror glass is shot…can I get a replacement? I hear it’s smaller than 250/280s…also,the little black plastic flipper/ dipper thing snapped..fatigued I guess,..can these be found ,or failing that reglued together some how?
Thank you all in advance..

Title: Re: Interior rear view mirror
Post by: FGN59 on June 27, 2021, 11:59:10

As I am not the one doing it, it’s easy to ask: would this be a good candidate for 3D replica manufacturing?

Title: Re: Interior rear view mirror
Post by: Bob G MN on June 27, 2021, 18:09:11

I got the glass from authentic classics

Title: Re: Interior rear view mirror
Post by: Brennie on June 28, 2021, 05:46:04

3D modelling… great idea.. I’ll look into it… meanwhile , I’d like to find a replacement…

Title: Re: Interior rear view mirror
Post by: WRe on June 28, 2021, 06:31:53

Hi,
I haven't seen the "flipper" for a 230-rearview mirror but the later versions have a thin sheet metal inside to realize a stable flip mechanism.
Will this be possible with 3D-printing?
...WRe

Title: Re: Interior rear view mirror
Post by: FGN59 on June 28, 2021, 06:44:45

It’s been a while since I disassembled mine to clean the glass (there was an ugly kind of rusty patch on the inside which went away with a careful but thorough cleaning). I think I remember actually dropping the small metal spring in that plastic ‘flipper’ as I was reassembling the unit, putting it back in and finding it all worked fine after. So if I remember correctly the metal spring can be inserted into the black plastic flipper afterwards.

Title: Re: Interior rear view mirror
Post by: Shvegel on June 28, 2021, 10:43:39

In all likelihood the mechanism or "flipper" is the same as sedan's of the era.  I doubt Mercedes would go through the expense of "reinventing the wheel."

Title: Re: Interior rear view mirror
Post by: Brennie on June 28, 2021, 12:17:06

I trying to get the glass resilvered but that little thing just snapped as I was reassembling the whole thing.. I could try to epoxy it I guess.. taking apart another old mirror might be an option too… it would mean sourcing one then, taking it apart in the hope it’s the right shape and fit… which is ok if it’s only a few £s but…. It’s a Mercedes…