Author Topic: 230 manual steering leak  (Read 3702 times)

catchersmit

  • Guest
230 manual steering leak
« on: May 26, 2016, 15:23:47 »
Does anybody have a source for a seal/rebuild kit for the 230 manual steering box? Mine is leaking where the pitman arm is attached to the box. I have looked (I think) everywhere.

ctaylor738

  • Full Member
  • Platinum
  • ******
  • USA, VA, Falls Church
  • Posts: 1127
Re: 230 manual steering leak
« Reply #1 on: May 28, 2016, 16:29:48 »
You can try a Mercedes dealer.  The EPC shows the following as "Optional with," meaning any of them should work.

001 997 93 46
002 997 71 46
002 997 72 46
Chuck Taylor
1963 230SL #00133
1970 280SL #13027 (restored and sold)
1966 230SL #15274 (sold)
1970 280SL #14076 (sold)
Falls Church VA

catchersmit

  • Guest
Re: 230 manual steering leak
« Reply #2 on: May 31, 2016, 16:46:23 »
Thanks.  I'll try.

alchemist

  • Senior
  • ***
  • USA, NY, GRAND ISLAND
  • Posts: 164
Re: 230 manual steering leak
« Reply #3 on: June 01, 2016, 17:31:56 »
Leaking of steering box of older Mercedes is notorious. If the leak is minor, I would just add transmission fluid to the reservoir, it is cheaper and easier than repairing it. I have several of them and they all leak, I do have a repair kit, but I never used it.

Stimorolgum

  • Guest
Re: 230 manual steering leak
« Reply #4 on: October 31, 2016, 14:59:06 »
Thanks for the info.
My steering box is a bit wet, guess I have to live with it. The seals seem to be in good condition.
Is there a way to drain the manual steering box or just suck out the fluid from the top?

Should I fill it to the top through the crew on top of the box?

Cheers  :)

Benz Dr.

  • Vendor
  • Platinum
  • ******
  • Canada, ON, Port Lambton
  • Posts: 7136
  • Benz Dr.
Re: 230 manual steering leak
« Reply #5 on: November 01, 2016, 05:13:39 »
Most, but not all seals are standard issue. I expect that seal would be readily available if you had the size.

Manual steering box uses gear lube as there is no pressurized fluid being used.
1966 230SL 5 speed, LSD, header pipes, 300SE distributor, ported, polished and balanced, AKA  ''The Red Rocket ''
Dan Caron's SL Barn

1970  3.5 Coupe
1961  190SL
1985   300CD  Turbo Coupe
1981  300SD
2013  GMC  Sierra
1965  230SL
1967 250SL
1970 280SL
1988 560SEC

Charles 230SL

  • Full Member
  • Gold
  • *****
  • USA, GA, Griffin
  • Posts: 654
  • 64 230SL
Re: 230 manual steering leak
« Reply #6 on: November 01, 2016, 19:22:15 »
Several years ago I replaced both the pitman arm and steering shaft seals on my 230's manual steering box. Bud's Benz had the seals and there really wasn't anything special about them. you'll need to pull the steering box to get to the seals and while you have it out, may be a good idea to go ahead and replace the nylon bushings for the steering coupler.

« Last Edit: November 02, 2016, 03:22:10 by Charles 230SL »

turbinmech

  • Guest
Re: 230 manual steering leak
« Reply #7 on: November 26, 2016, 08:02:45 »
I have a 66 230sl that had a bad steering gear box leak. You may try to get a seal kit and reseal it ,but most of the time it doesn't work. I found a very good gear box rebuilder on line called C&M hydraulics. I bought a rebuilt box from them thru a vender and installed it . No more leaks and better steering response. The only thing is that on early 230sl models there is coupler above the box that the bushings on the steering coupler were out. These must be replaced at the same time as the box is replaced.  Once that is done you have a tight leak free responsive steering system.
Cheers  John P Kelly Livermore Ca